Pick your calibre and your barrel's twist rate. We will tell you which bullet weights that barrel will stabilise, and show you the ammunition we stock that fits.
Not sure? It is in the spec sheet, often engraved on the barrel, and in the manual. Or tell us the make and model and we will look it up.
The same figures the tool uses, in one table. These are the practical numbers from our bullet weights and twist rates guide, which explains where they come from.
| Calibre | Twist | Bullet weights it will stabilise |
|---|---|---|
| .223 Remington | 1:12 | 50 to 55 grain |
| 1:9 | up to around 69 grain | |
| 1:8 | up to 77 grain | |
| 1:7 | everything | |
| .243 Winchester | 1:10 | 87 to 100 grain |
| 1:8 | 87 to 100 grain, plus the heavier and very low drag bullets | |
| 6.5 Creedmoor | 1:8 | 95 to 147 grain |
| .308 Winchester | 1:12 | 150 to 180 grain |
| 1:10 | 150 to 180 grain, with headroom above it | |
| .22 LR | 1:16 or 1:16.5 | all standard .22 LR |
| .17 HMR | 1:9 | 17 and 20 grain |
Every twist rate here was checked against the maker's own published specification on 22 November 2026: Bergara, Tikka, Howa, CZ and Anschutz for the rifles, Sierra for the minimum twist per bullet, and Hornady for the factory weight ranges. The guide lists the sources in full.
Shooting something not listed? Tell us the rifle and what you use it for and we will suggest loads worth trying.
If the holes in your target are oval or sideways, that is keyholing: the bullet is arriving tipped over, and that load will never work in that barrel. Marginal stability also gets worse in winter, when cold dense air asks more of the bullet.
1:8 or faster. A 1:9 is marginal with most 75 to 77 grain bullets and a 1:12 has no chance. In a 1:9 or slower barrel, stay at 69 grains or below.
The manufacturer's spec sheet, the barrel engraving or the manual. Failing that, push a tight patch down the bore on a marked cleaning rod and measure how far it travels for one full rotation: that distance in inches is the twist. Or tell us the make and model and we will look it up.
No. What the barrel has to stabilise is bullet length, and a sleek high-BC match bullet is long for its weight. A lead-free copper bullet is longer again than lead of the same weight, so it asks for more twist.
Ammunition is collected from us by appointment and the calibre must be on your certificate. Arrange a collection.